EVO-ONE DCRYPTOR Programming Issue

Question

I am finally installing my EVO-ONE with THAR-TOY-13 on my 2021 Toyota RAV4 Hybrid, after four years since I purchased it.

While following the programming procedure, I am stopped at step 4, because the expected result is not achieved.

1) Press and hold the programming button: Connect the 4-PIN Data-link harness (Black connector). - The BLUE, RED, YELLOW and BLUE & RED LEDs will alternatively illuminate. - CHECK

2) Release the programming button when the LED is BLUE. - CHECK

3) Insert the required remaining connectors. - CHECK

4) Do not press the brake pedal. Press the Push-to-Start button twice to turn on the ignition. - Wait for the BLUE LED to flash rapidly and constantly. - PROBLEM: After pressing the start button two times, all of the LEDs turn off and the blue LED does not flash at all

I have already reset the device by disabling protection and then following resetting procedure in car (release button on red LED and then press again and hold until LEDs flash in sequence)  - However still the problem presists.

Can this problem be fixed? - Thanks